HOW TO LOAD THE ALPHA GUN WITH A CO2 CAPSULE
1º The pistol is normally sent loaded with gas with a CO2 capsule mounted for the customer to test the gun and especially so that once exhausted the CO2 load - TOTALLY, when removed, the customer can see well in how it goes Mounted capsule, careful !! Goes beyond what is customary, the drill bit should be placed outside.
2º The gun always has two plugs, IDENTICAL, to puncture the gas caps, these plugs, ALWAYS must be used ALTERNATIVELY, IN ANY CASE (and ensure that the inner O rings are not dry, that is to say keep them slightly oiled), doing this As well as fitting them well, it is necessary to screw until the end, that is to say, not transverse or bad mounted, the problem is solved, the pistol is loaded quickly without effort some. The plugs that puncture the capsule are fitted with the pipe wrench that accompanies the weapon, not by hand and are rotated until we hear that, inside the tank, the capsule has been pierced and the cap has come to its place . The hull, ie the metal of the capsule remains inside the tank of the weapon until the gas runs out and we change the capsule to a new one.
3º VERY IMPORTANT, BEFORE CARRYING UP A NEW CO2 CAPSULE, REMEMBER THAT THE PISTOL MUST HAVE THE MOUNTED TRIGGER (fins of the firing pin assembly carried to the tip of the gun barrel), otherwise the valve of the Gun will remain open and all the gas you enter will exit through the barrel.
4º The pipe wrench is intuitive, it has a projection in the interior, visible to the naked eye, that hooks with a notch in the plug, CAUTION! If ever, you notice that a plug offers a lot of resistance to leave its housing that indicates that there is pressure inside the tank because you have forgotten to empty 100% of the residual gas gun, ALWAYS, before removing a plug, be sure to empty 100 % gas, is emptied by throwing empty shots as safer means.